Make sure the AIO’s slightly bigger size can fit your own quad! The size of this AIO is 36.5(L)*36.5(W)*7.0(H)mm.
We suggest you use this AIO on your 3.5″ to 5″ cinewhoops/long-range or lightweight quads.For quads below 3.5″,you should carefully check if your quad has enough room for this AIO.
Specifications
Product Name SpeedyBee F745 35A BLS AIO
Power Input 3S – 6S Lipo
Mounting 25.5 x 25.5mm, 3mm hole diameter
Dimension 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above
Weight 10.1g
Flight Controller
MCU STM32F745
IMU(Gyro) MPU6000
USB Connection Need to solder a USB TYPE-C module to D+,D-,GND pads.
Barometer BMP280
OSD Supported
BLE Bluetooth Supported. Used for parameter configuration,built-in a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip
Flash FC Firmware Wirelessly Supported
Download/Analyze Blackbox Supported
DJI Air Unit 6-pin Connector Built-in.
Flash(for BlackBox) 8MB
Current Sensor Supported. Scale=256
BetaFlight Camera Control Pad Yes(CC pad)
5V Output 4 groups of 5V output. The total current load is 2.5A.
9V Output None
ESC Signal Pads M1 – M4
UART Full UART * 4(UART1, UART2, UART3,UART4)
ESC Telemetry UART None
I2C Supported.
LED Pad Used for WS2812 LED
Buzzer BZ+ and BZ- pad used for 5V Buzzer
BOOT Button Used to enter DFU mode
RSSI Input Not supported
SmartPort Not Supported
Supported Flight Controller BetaFlight(Default)
Firmware Target Name SPEEDYBEE F745AIO
Reviews
There are no reviews yet.